Double milker cumshot clips

Description:If the float is not moving remove the vacuum pipe small pipe and fit again Keep the ball valve of teat adapter cluster open and switch on the machine then close ball valve Wait till vacuum gauge shows to mm of Hg reading Meanwhile prepare cow for milking by cleaning and massaging the udder Once animal is stimulated for letdown, hold the teat adapter cluster in one hand and insert the teat into teat liners of teat adapter cluster Slowly open the ball valve of teat adapter cluster and teat adapter will clutch on teats and udder of animal Leave teat adapter cluster to hang on udder while the machine is running When milk flow in pipe becomes less after three or four min, slightly pull the cluster assembly down to exert extra force on udder while operating the pump, which helps to drain the milk quickly. We export our products all over the World. Take 3 Liter boiling water in bucket close the lid of milk can Dip teat adapter cluster in boiling water Switch on and run the milking machine and boiling water flows thru the milk pipe into milk can While water flows through, gently lift and dip the cluster in water so that water gets blasted inside Use enough boiling water about three liter to clean the machine thoroughly Open the teat adapter cluster and milk can, wash it thoroughly If required use mild detergent and brush. Our company is Sole Proprietorship Individual , based company. Do not dip can lid in water and operate the machine Do not dip open pipe in water and operate the machine Periodic Maintenance: Easy to operate How to operate: Before milking clean the milk can, inside of teat liners and milk pipe by dipping the teat liner cluster in clean water and operating the machine Flush out the water from liner and milk can Close can lid and cluster, ensure the clips are secured in place.

Views: 3195 Date: 2018-07-02 Favorited: 78